Rom Flash How to Flash Mediatek Chipset's Stock Firmware Rules_Full Tuitorial Method

[Rom] Flash How to Flash Mediatek Chipset's Stock Firmware Rules_Full Tuitorial Method

Flashing stock firmware on Mediatek chipset devices can be done using various tools, but the general steps and rules to follow are:

Before you begin:

Make sure you have the correct firmware file for your device model and variant.
Charge your device to at least 50% or more to avoid any interruptions during the flashing process.
Backup your important data and files, as flashing stock firmware will erase everything on your device.
Install Mediatek USB drivers on your computer, which can be downloaded from the official website of your device's manufacturer or from the Mediatek website.

Step 1: Download and Extract Firmware

Download the stock firmware file for your device model and variant from a trusted source.
Extract the firmware files to a location on your computer using a file extraction software, such as WinZip, WinRAR, or 7-Zip.

Step 2: Install Flash Tool

Download and install the Mediatek flash tool on your computer. Some popular Mediatek flash tools are SP Flash Tool, MTK Flash Tool, and MediaTek Smart Phone Flash Tool.
Launch the flash tool program as administrator.

Step 3: Load Firmware into Flash Tool

In the flash tool, click on the "scatter-loading" button and browse to the extracted firmware folder.
Select the scatter file that corresponds to your device, which will load the firmware files into the flash tool.

Step 4: Configure Flash Tool Settings

In the flash tool, select the appropriate options for your device, such as Download Only or Firmware Upgrade mode.
If necessary, select the correct download agent file (DA file) for your device. The DA file is usually located in the firmware folder, or you can download it separately.

Step 5: Connect Device to Computer

Turn off your device and connect it to your computer via USB cable.
Press and hold the volume down or up button (depending on the device) to enable the device to be detected by the flash tool.
Once the device is detected, the flashing process will start automatically.

Step 6: Wait for Flashing Process to Complete

Do not interrupt the flashing process, as it could damage your device.
Wait for the flashing process to complete. The progress bar in the flash tool will indicate the status of the process.
Once the flashing process is complete, you will see a green tick or a success message in the flash tool.

Step 7: Disconnect Device and Power On

Disconnect your device from the computer.
Power on your device and wait for it to boot up. This may take longer than usual for the first boot after flashing.